Dell XPS 8900 - Removing the Front USB-Panel; Prerequisites; Procedure

Removing the front USB-panel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the computer cover.
2 Remove the front bezel.
Procedure
CAUTION: Be extremely careful while sliding the front USB-panel out of the
computer. Carelessness may result in damage to the cable connectors and
the cable routing clips.
NOTE: Note the routing of all cables as you remove them so that you can
re-route them correctly after you replace the front USB-panel.
1 Press the securing clip and disconnect the front USB-panel cables from the
system board. For more information, see "System-board components".
2 Remove the screw that secures the front USB-panel to the front panel.
3 Slide the front USB-panel down and pull it away from the chassis.
77