Removing the power-button
module
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the right-side cover.
2 Remove the top cover.
3 Remove the front bezel.
Procedure
NOTE: Note the routing of the cable as you remove it so that you can
reroute it correctly after you replace the power-button module.
1 Disconnect the power-button module cable from the system board.
For more information, see “System-board components”.
2 Note the power-button module cable routing and remove the cable from the
routing guides next to the system board on the chassis.
3 Remove the screw that secures the power-button module and lift the power-
button module from the chassis.
82
To Next Page
Loading...
