52 Display
18
Lift the display assembly off the computer base.
Replacing the Display Assembly
1
Follow the instructions in "Before You Begin" on page 9.
2
Place the display assembly in position and replace the four screws that
secure the display assembly to the computer base.
3
Route the display cable through the routing guides and connect the
display cable to the system-board connector.
4
Connect the digitizer board cable to the system-board connector.
5
Tighen the captive screw that secures the display grounding cable.
1 display assembly 2 screws (4)
3 display cable 4 top cover
5 antenna cables
To Next Page
Loading...
