Camera Module 61
13
Camera Module
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell™ is not covered
by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 13) before working inside the computer.
Removing the Camera Module
1
Follow the instructions in "Before You Begin" on page 9.
2
Remove the battery (see "Removing the Battery" on page 13).
3
Remove the module cover (see "Removing the Module Cover" on
page 15).
4
Remove the memory module(s) (see "Removing the Memory Module(s)"
on page 17).
5
Remove the palm-rest assembly (see "Removing the Palm-Rest Assembly"
on page 29).
6
Remove the keyboard (see "Removing the Keyboard" on page 43).
7
Remove the display assembly (see "Removing the Display Assembly" on
page 49).
8
Remove the display bezel (see "Removing the Display Bezel" on page 53).
9
Disconnect the camera cable from the connector on the camera module.
To Next Page
Loading...
