Dell XPS M1210 - Display Assembly; Removing the Display Assembly

Back to Contents Page
 Display
Dell™XPS™M1210ServiceManual
Display Assembly
Display Bezel
Display Panel
Display-Panel Brackets
Display Assembly

Removing the Display Assembly


1. Follow the instructions in Before Working Inside Your Computer.

2. Turn the computer upside down and loosen the captive screw on the communications card cover.

3. Disconnect the antenna cables from the Mini-Card(s), if applicable.

4. Turn the computer top-side up.

5. Remove the hinge cover (see Removing the Hinge Cover).

6. Remove the keyboard (see Keyboard).
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the
computer.
NOTE: You must detach the Mini-Card (WLAN and/or Mobile Broadband) antenna cables (see step 3) before you can remove the display assembly. If a
Mini-Card is installed, disconnect the antenna cables from the card(s). If one is not installed, detach the antenna cables from their secured location.