Dell XPS M1210 - Right Side View


2. Replace the four M2.5 x 5-mm screws on the corners of the bezel.

3. Replace the four rubber bumper/screw covers around the bezel.
Display Panel

Removing the Display Panel


1. Follow the instructions in Before Working Inside Your Computer.

2. Remove the display assembly (see Removing the Display Assembly).

3. Remove the display bezel (see Removing the Display Bezel).

4. If an optional camera is present on the computer, disconnect the camera cable connector.

5. Remove the four M2 x 3-mm screws (two on each side of the display panel).

6. Remove the M2 x 3-mm ground screw that attaches the display-panel ground wire to the display back cover.

7. Turn the display assembly over so that the display panel is face down and the display hinges are toward you.

8. Lift the display back only enough to allow you to disconnect the speaker connector.

9. Lift the display back cover away from the display panel.

10. Remove the display-panel brackets from the display panel (see Removing the Display-Panel Brackets).

11. Remove the cable assembly from the back of the display panel:
NOTE: To facilitate replacement of the display bezel, ensure that the camera connector is tucked in place beside the display panel before you snap the
bezel into place.
1
camera cable connector (present only
on computers with an optional camera)
3
display panel
5
display back
cover
2
M2 x 3-mm screws (4)
4
M2 x 3-mm display-cable
ground screw and ground
wire
6
speaker
cable
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface (such as the back
panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the
computer.