Dell XPS M1210 - Camera (Optional); Removing the Camera; Replacing the Camera

Back to Contents Page
 Camera (Optional)
Dell™XPS™M1210ServiceManual
Removing the Camera
Replacing the Camera
Removing the Camera


1. Follow the instructions in Before Working Inside Your Computer.

2. Remove the hinge cover (see Removing the Hinge Cover).

3. Remove the keyboard (see Keyboard).

4. Remove the display assembly (see Removing the Display Assembly).

5. Remove the display bezel (see Removing the Display Bezel).

6. Remove the display panel (see Removing the Display Panel).

7. Remove the two M2 x 3-mm screws that attach the camera to the display back cover.

8. Detach the camera cable from the display back cover by lifting the tape that secures it to the cover.
Replacing the Camera

1. With the camera lens facing up, insert the tab at the top-left of the camera into the detent at the bottom-left edge of the camera bezel.
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the
computer.
NOTE: The camera is an optional feature.
1
tape
3
camera
2
M2 x 3-mm screws (2)
4
display back cover