Dell XPS M1330 - Removing the Display Panel Cable; Removing the Display Hinges

Display Assembly: Dell XPS M1330 Service Manual
file:///C|/Users/SIIES/Downloads/Dell XPS 1330/display.htm#wp1109848[16/07/2010 06:28:06 p.m.]
5. Replace the display bezel (see Replacing the Display Bezel).
Removing the Display Panel Cable
1. Remove the display assembly (see Removing the Display Assembly).
2. Remove the display bezel (see Removing the Display Bezel
).
3. Remove the display panel (see Removing the Display Panel
).
4. Turn over the display panel, placing it on a clean surface.
NOTICE: To avoid damage to the computer when replacing the bottom flex cable, gently support the bottom of the
inverter board with one finger as you reseat the bottom flex-cable connector. Do not bend the inverter board.
5. Gently pull the pull-tab on the bottom flex-cable connector to release the cable from the inverter board.
6. Squeeze the flex-cable release levers at either side of the top flex-cable connector, releasing the connector.
1 pull-tab 2 back of display panel
3 flex cable
Removing the Display Hinges
1. Remove the display assembly (see Removing the Display Assembly).
2. Remove the display bezel (see Removing the Display Bezel
).
3. Remove the display panel (see Removing the Display Panel
).
4. Remove the four screws (two on each side) that secure the hinge to the display back.