126 Adding and Replacing Parts
5
Pull up on the plastic bar that secures the keyboard cable to the system
board and remove the keyboard
Replacing the Keyboard
1
Slide the keyboard connector into the slot until it clicks and pull down on
the plastic bar that secures the keyboard connector to the system board.
2
Align the five tabs along the bottom of the keyboard and slide them under
the palm rest.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-
consuming to replace. Be careful when removing and handling the keyboard.
3
Replace the two M2 x 2-mm screws along the top of the keyboard.
1 M2 x 2-mm screw (2) 2 keyboard
3 keyboard tabs (5) 4 keyboard cable
5 plastic securing bar
1
2
3
5
4
To Next Page
Loading...
