150 Adding and Replacing Parts
4
Remove the M2 x 3-mm securing screw.
5
Remove the FCM.
Replacing the FCM
NOTICE: Install the FCM in the WWAN or WPAN slot. Do not install an FCM in the
WLAN card slot. Doing so may cause damage to your computer.
1
Insert the
FCM
connector at a 45-degree angle into the system board
connector labeled "FCM".
2
Press the other end of the
FCM
down into the slot on the system board
until the card clicks into place.
3
Replace the M2 x 3-mm securing screw.
1 FCM Card 2 M2 x 3-mm securing screw
2
1
book.book Page 150 Friday, November 30, 2007 11:28 AM
To Next Page
Loading...
