Adding and Replacing Parts 151
Internal Card With Bluetooth
®
Wireless Technology
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
If you ordered a card with Bluetooth wireless technology with your computer,
it is already installed.
Removing the Card
1
Follow the procedures in "Before You Begin" on page 131.
2
Remove the center control cover (see "Removing the Center Control
Cover and Hinge Covers" on page 136).
3
Pull the bluetooth card out of the box.
4
Disconnect the cable connector from the card to remove the card from the
computer.
1 box 2 card 3 cable connector
2
1
3
book.book Page 151 Friday, November 30, 2007 11:28 AM
To Next Page
Loading...
