Internal Card With Bluetooth
®
Wireless Technology 13
2
Internal Card With Bluetooth
®
Wireless Technology
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the
Product Information Guide
.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
If you ordered a card with Bluetooth wireless technology with your computer,
it is already installed. The Bluetooth wireless technology card is located in the
battery compartment.
Removing the Card With Bluetooth
®
Wireless
Technology
1
Follow the procedures in "Before You Begin" on page 9.
2
Ground yourself by touching one of the metal connectors on the back of
the computer.
NOTE: If you leave the area, ground yourself again when you return to the
computer.
3
Pull the card out of the battery compartment so that you can disconnect
the card from its cable and remove it from the computer.
To Next Page
Loading...
