24 Coin-Cell Battery
5
Remove the battery from the compartment on the system board by using a
scribe or small screwdriver to lift one side of the battery at the notch in the
plastic connector, being careful not to break the plastic.
6
Grasp the battery and pull it out of the battery compartment.
7
To install the coin-cell battery:
a
Insert the edge of the coin-cell battery into the plastic battery
compartment under the lip on the compartment.
b
Carefully press the coin-cell battery into the compartment, being
careful not to break the plastic.
8
Replace the keyboard (see "Replacing the Keyboard" on page 28).
9
Replace the hinge cover (see "Replacing the Hinge Cover" on page 26).
1 scribe 2 coin-cell battery
To Next Page
Loading...
