132 Adding and Replacing Parts
NOTICE: To avoid damaging the system board, you must remove the battery before
you begin working inside the computer.
1
Follow the procedures in "Before You Begin" on page 123.
2
Turn the computer over and loosen the captive screws from the Mini-
Card/modem cover.
3
Place your finger under the cover at the indentation, and lift the cover to
remove it.
4
If a Mini-Card is not already installed, go to step 5. If you are replacing a
Mini-Card, remove the existing card:
a
Disconnect the antenna cables from the Mini-Card.
To Next Page
Loading...
