Using Cards 71
The computer recognizes the ExpressCard and automatically loads the
appropriate device driver. If the configuration program tells you to load the
manufacturer's drivers, use the media that came with the ExpressCard.
Removing an ExpressCard or Blank
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
Press the latch and remove the card or blank. For some latches, you must
press the latch twice, once to pop the latch out, and then a second time to
pop the card out.
Save a blank to use when no ExpressCard is installed in a slot. Blanks protect
unused slots from dust and other particles.
1 slot 2 ExpressCard
1 2
To Next Page
Loading...
