Replacing the Top Cover
1. While holding the top cover in one hand, connect the optical drive cable to its connector on the system board (JOD) and the media cable to its connector
on the system board (JMEDIA).
2. Set the top cover in place and attach it to the computer with six M2.5 x 5-mm screws on the left side and seven M2.5 x 5-mm screws on the right side of
the top cover at the embossed arrows.
3. Replace the cosmetic covers (see Replacing the Cosmetic Covers).
4. Firmly attach the keyboard to the computer and close the display (see Closing the Display).
5. Turn the computer upside down and replace the system battery (see Replacing the System Battery).
Back to Contents Page
To Next Page
Loading...
