Back to Contents Page
Camera
Dell™XPS™M2010ServiceManual
Removing the Camera
Replacing the Camera
Removing the Camera
1. Follow the instructions in Before Working Inside Your Computer, including removing the system battery.
2. Turn the computer over and open the display (see Opening the Display).
3. Detach the keyboard by grasping the sides of the keyboard and pulling it straight out from the computer base. Set the keyboard aside.
4. To access the camera, follow the instructions for removing the black display bezel and the silver display inlay (see Removing the LCD Panel).
5. Disconnect the camera cable from the connector on the display.
6. Remove the five M2 x 3-mm screws that attach the camera and cable to the top of the display.
Replacing the Camera
1. Attach the new camera and cable to the top of the display with five M2 x 3-mm screws.
2. Connect the camera cable to the connector on the display.
3. Follow the instructions for replacing the silver display inlay and the black display bezel (see Replacing the LCD Panel).
4. Firmly attach the keyboard to the computer and close the display (see Closing the Display).
5. Turn the computer upside down and replace the system battery (see Replacing the System Battery).
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface. If you leave the area, ground yourself again when you return
to the computer.