Dell XPS M2010 - Using a Battery; Replacing the Battery


3. Lift the optical drive out of the assembly.

4. Remove the two drive rails from the optical drive by removing the two M2 x 3-mm screws in each drive rail.

5. Remove the optical drive cable from the optical drive by removing the two M2 x 3-mm screws.

6. Remove the four M2.0-mm shoulder screws on the optical drive cover.

7. Slide the top cover away from the front bezel to disengage the tabs, and lift the drive cover off the drive.

8. Remove the media from the drive.
1
M2.0-mm shoulder screws (4)
2
optical drive
3
optical drive assembly
1
optical drive rails (2)
2
optical drive
3
M2 x 3-mm screws on rails (4)
1
M2.0-mm shoulder screws (4)
2
optical drive
3
front bezel