Dell XPS M2010 - Lost or Stolen Computer


Installing the Optional Hard Drive Fan

1. Slide the fan between the hard drive bays until it snaps into place.

2. Connect the fan cable to the FAN_HDD connector on the system board (see System Board Components).

3. Replace the computer cover (see Replacing the Computer Cover).

4. Connect your computer and devices to electrical outlets, and then turn them on.
System Board


Removing the System Board

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Disconnect the fan cable from the FAN_CAGE connector on the system board (see System Board Components).

4. Remove any full-length expansion cards (see Removing PCI and PCI Express Cards).

5. Remove the two screws securing the card fan assembly, then remove the assembly and set it aside.
1
hard-drive fan release latch
2
hard drive fan
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide
NOTICE: The system board and metal tray are connected and are removed as one piece.