132 Adding and Replacing Parts
Mini Card
If you ordered a wireless LAN (WLAN) card with your computer, the card is already installed.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically
touching a connector on the back panel of the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside
the computer.
WLAN Cards
1
Follow the procedures in "Before You Begin" on page 127.
2
Remove the memory cover. See "Memory" on page 129.
3
Ground yourself by touching one of the metal connectors on the back of the computer.
NOTE: If you leave the area, ground yourself again when you return to the computer.
4
If a card is not already installed, go to step 5. If you are replacing a card, remove the existing card:
a
Disconnect the antenna cables from the card.
1 antenna cables
1
book.book Page 132 Tuesday, February 13, 2007 1:50 PM
To Next Page
Loading...
