28 Using the Keyboard and Mouse
Keyboard Pairing Failed
If your computer fails to recognize the keyboard, follow these steps:
1
Press the power button to turn the computer off, and then press the power button again to restart the
computer; wait about three minutes for the operating system to load and the computer to initialize the
drivers.
2
Press the wireless connection button on the left side of the computer base and hold until the Bluetooth
light on the computer flashes.
3
Press the wireless connection button on the back of the keyboard and hold for about four seconds to
put the keyboard into "discover" mode. The Caps lock, Scroll, and Num lock wireless Bluetooth lights
on the keyboard will be solid blue. Release the wireless connection button on the keyboard and these
lights will all start flashing.
The computer may go through a series of beeps before the pairing occurs.
4
Test the pairing by touching the touchpad to move the cursor to ensure that pairing was successful.
If pairing was unsuccessful, repeat these steps as necessary to pair your keyboard with your computer.
1 wireless connection button on computer base
1 wireless connection button on keyboard
1
1
book.book Page 28 Tuesday, February 13, 2007 1:50 PM
To Next Page
Loading...
