Using the Keyboard and Mouse 31
3
Using the keyboard or touchpad, select
Start
→
Turn Off Computer
→
and click
Turn O f f
to shut down
the computer, then press the power button to restart the computer. Wait about three minutes for the
operating system to load and the computer to initialize the drivers.
4
Follow the instructions on the Wizard. Power on the mouse by sliding the switch on the bottom of the
mouse to the
On
position, and press the wireless (Bluetooth) connection button on the bottom of the
mouse.
5
Click
Next
on the
Wizard
within 30 seconds to complete the pairing. The message
Your mouse
has been connected and is ready to use
displays when the pairing is complete. Use
the mouse to click
Finish
to complete the pairing. After completing the pairing, the blue wireless light
on the mouse will stop blinking and continue to light for 2 to 3 seconds, and then go out.
Numeric Keypad
The numeric keypad functions like the numeric keypad on an external keyboard. Each key on the keypad
has multiple functions.
• To enable the keypad, press <Num Lk>. The light indicates that the keypad is active.
• To disable the keypad, press <Num Lk> again.
Key Combinations
System Functions
1 numeric keypad
<Ctrl><Shift><Esc> Opens the Task Manager window.
1
9
book.book Page 31 Tuesday, February 13, 2007 1:50 PM
To Next Page
Loading...
