156 Adding and Replacing Parts
3
Turn the computer over, loosen the captive screws on the memory module
cover, and then remove the cover.
NOTICE: To prevent damage to the memory module connector, do not use tools to
spread the memory-module securing clips.
4
If you are replacing a memory module, remove the existing module:
a
Use your fingertips to carefully spread apart the securing clips on each
end of the memory module connector until the module pops up.
b
Remove the module from the connector.
1 captive screws (2) 2 memory module cover
1
2
book.book Page 156 Monday, April 14, 2008 4:23 PM
To Next Page
Loading...
