160 Adding and Replacing Parts
Internal Card With Bluetooth™ Wireless Technology
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
If you ordered a card with Bluetooth wireless technology with your computer,
it is already installed. The Bluetooth wireless technology card is located in the
battery compartment.
1
Follow the procedures in "Before You Begin" on page 149.
2
Ground yourself by touching one of the metal connectors on the back of
the computer.
NOTE: If you leave the area, ground yourself again when you return to the
computer.
3
Pull the card out of the battery compartment so that you can disconnect
the card from its cable and remove it from the computer.
4
To replace the card, connect the card to the cable and insert it into the
compartment.
5
Replace the battery.
1 internal card with Bluetooth™ Wireless technology 2 cable
3 bluetooth compartment
2
1
3
book.book Page 160 Monday, April 14, 2008 4:23 PM
To Next Page
Loading...
