11
Auto-off
Please note
The appliance is set to turn off automatically if
not used for 2 hours.
The time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1,
2 or 3 hours.
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 8) until the
light comes on;
3. Press the
button to select the function;
4. Turn the selection knob until the lights corre-
sponding to the number of hours before the
appliance goes off automatically come on:
15 minutes
30 minutes
1 hour
2 hours
3 hours
5. Press the
button to confirm;
6. Press the
button to exit the menu.
Auto-off is programmed.
Setting the temperature
To modify the temperature (low, medium, high)
of the water used to make the coffee, proceed
as follows:
1. Press the P button to enter the menu;
2. Turn the selection knob until the
light
comes on;
3. Press the
button;
4. Turn the selection knob until the lights corre-
sponding to the required temperature come
on:
LOW
MEDIUM
HIGH
5. Press the
button to confirm;
6. Press the
button to exit the menu.
Energy Saving
Use this function to enable or disable energy
saving mode. This mode is active by default, re-
ducing energy consumption while the machine
is on in compliance with current European regu-
lations.
1. Press the P button to enter the menu;
2. Turn the selection knob until the light E co-
mes on.
3. Press the
button. The OK light flashes.
4. Press the
button to activate, or to
deactivate, the energy saving mode;
5. Press the
button to exit the menu.
When the function is active, the E light remains
on.
Please note!
A few seconds may elapse between energy sa-
ving mode and delivery of the first coffee as the
appliance must heat up again.
Setting water hardness
For instructions on setting water hardness, see
page 17.
Install filter
For instructions on how to install the filter, see
the section “Installing the filter” on page 11.
Replacing the filter
For instructions on how to replace the filter, see
the section “Water softener filter” on page 17.
Default values (reset)
This resets all menu settings and programmed
quantities back to the default values.
1. Press the P button to enter the menu;
2. Turn the selection knob until the
lights come on;
3. Press the
button. The OK light flashes;
5. Press the
button to confirm and exit.
Statistics function
This displays statistics relating to the machine.
To display, proceed as follows:
1. Press the P button to enter the menu;
2. Turn the selection knob until the
light
comes on;
3. Press the
button;
4. When the selection knob is turned and the
corresponding light flashes, the following
information is displayed:
-
how many coffees have been made;
- how many times the machine has been
descaled;
-
the total number of litres of water deli-
vered;
To Next Page
Loading...
