DeLonghi Eletta Automatic - Cleaning Coffee Grounds Container; Cleaning Drip and Condensate Tray

18
2. Remove all the residues with a vacuum cleaner (g. 34).
11.6 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener lter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank.
4. (Models with water softener lter only) Deliver about 3,38
.oz/100 ml of water.
11.7 Cleaning the coee spouts
35
1. Clean the coee spouts (A7)
regularly with a sponge or
cloth (g. 35).
2. Check that the holes in
the coee spouts are not
blocked.
If necessary, remove coee de-
posits with a toothpick (g. 35).
11.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground
coee funnel (A4) is not blocked. If necessary, remove coee
deposits with the brush (C5) supplied.
11.9 Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
“6. TURNING THE APPLIANCE OFF”).
2. Remove the water tank (A16- g. 3).
3. Open the infuser door (A14- g. 36) on the right side of the
appliance.
36
37
PUSH
PUSH
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 37);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 38), then push the PUSH symbol fully
in until it clicks into place.
38
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 39.
39
8. Once inserted, make sure the two coloured buttons have
snapped out (g. 40).
40
PUSH
9. Close the infuser door.
10. Put the water tank back.