DeLonghi Eletta Automatic - Page 25

24
The coee is delivered too slowly or a
drop at a time.
The coee is ground too nely. Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coee
mill is in operation (g. 14). Continue one click
at a time until coee delivery is satisfactory.
The eect is only visible after delivering 2
coees (see section “8.4 Adjusting the coee
mill”).
Coee does not come out of one or
both of the spouts.
The coee spouts (A7) are blocked. Clean the spouts with a toothpick (see section
“11.7 Cleaning the coee spouts”).
The appliance does not come on It is not plugged into the mains socket. Plug into the mains socket (g. 1).
The main switch (A19) is not turned on. Press the main switch (g. 2).
The infuser cannot be extracted The appliance has not been turned o
correctly
Turn the appliance o by pressing the
button (B1-g. 8) (section “6. TURNING THE AP-
PLIANCE OFF”).
The milk does not
come out of the milk
spout (D5)
The milk container lid (D2) is dirty. Clean the milk container lid as described in sec-
tion “11.10 Cleaning the milk container”.
The milk contains
large bubbles and
squirts out of the
milk spout (D5) or
there is little froth
The milk is not cold enough or is not
semi-skimmed.
Use skimmed or semi-skimmed milk at refrige-
rator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
The froth adjustment dial (D1) is incor-
rectly adjusted.
Adjust following the instructions in section
“9. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES”.
The milk container lid (D2) or froth
adjustment dial (D1) are dirty.
Clean the milk container lid and dial as de-
scribed in section “11.10 Cleaning the milk
container”.
The hot water/steam connection noz-
zle (A8) is dirty.
Clean the connection nozzle as described in
section “11.11 Cleaning the hot water/steam
connection nozzle”.
The milk contains
large bubbles and
squirts out of the
milk spout or there is
little froth.
The cappuccino maker/ hot water
spout (C6) is dirty.
Clean as described in section “10.5 Cleaning
the spout after use”.