DeLonghi Tasciugo AriaDry DEM 10 User Manual

Troubleshooting
Problem Cause Solution
The appliance does not
work in dehumidifying mode
(indicator light off)
The appliance is operating
in dehumidifying mode
(light on), but the humidity
does not decrease
•the appliance is not plug-
ged in
•no electricity
•the humidistat is on mini-
mum
•the tank is full of water
•the tank is incorrectly posi-
tioned
•the filter is blocked
•the temperature or humi-
dity in the room is too low
•the room is too large
•too many sources of humi-
dity in the room (pots of
boiling water, etc.)
•plug into the mains
•check the power supply
•turn the humidistat to the
max position
•empty the tank
•position the tank correctly
•clean the filter
•in certain conditions, it is
normal for the appliance
not to dehumidify (in these
cases the room being
dehumidified should also
be heated)
Check the following points before calling your local authorised Service Centre.
The appliance does not
work for around 3 minutes
when restarted
•The safety device has trip-
ped
•wait for 3 minutes to pass

DeLonghi Tasciugo AriaDry DEM 10 Specifications

General

Airflow	100 m³/h
Placement	Floor
Noise level	38 dB
Certification	CE
Product color	White
Number of speeds	1
Water tank capacity	2 L
Refrigerating medium	R134a
Humidity control type	Stepless
Water level indicator	Yes
Dehumidifying capacity (max)	10 l/24h
Suitable for room volume up to	50 m³
Power control	Electronic
AC input voltage	230 V
AC input frequency	50 Hz
Power requirements	AC
Power consumption (typical)	180 W
Operating temperature (T-T)	2 - 30 °C
Operating relative humidity (H-H)	30 - 95 %
Package depth	300 mm
Package width	360 mm
Package height	490 mm
Package weight	11000 g
Quantity per pallet	32 pc(s)
Quantity per master (outer) case	1 pc(s)

Weight and Dimensions

Depth	260 mm
Width	330 mm
Height	415 mm
Weight	10000 g