Rear Suspension
TRAILING ARM - RIGHT OR LEFT
REMOVAL
1.
Raise car on hoist and remove tyre and wheel
assembly.
2.
Remove screws securing the trailing arm shield
to chassis frame and remove shield.
3. Disconnect brake hose to rear brake line. Cap
hose and line.
4.
Unclip brake line from trailing arm.
5. Disconnect hand brake cable from hand brake
caliper
lever arm by removing the split pin and
clevis.
6. Remove two (2) bolts securing brake caliper
assembly to hub carrier. Remove caliper
assembly. Fig. 7
7. Remove brake disc.
8. Remove two (2) nuts and bolts, securing
trailing arm to hub carrier and disconnect
trailing arm from hub carrier.
INSTALLATION
1.
To complete installation reverse the removal
procedure, torque fasteners to specification.
Notice:
Fasteners must be torqued with car resting on
its suspension.
2.
Bleed brake system.
9. Remove trailing arm pivot bolt and nut.
j
Remove trailing arm from car. Inspect trailing
arm bushing for damage and replace if
necessary. Fig. 8
3. Check car suspension for specified toe-in
alignment and adjust if necessary.
4.
Adjust hand brake cable(s) if necessary.
To Next Page
Loading...
