TRAILING ARM BUSHING - RIGHT OR LEFT
REMOVAL
1.
Raise car on hoist.
3. Remove both bushing mounting plate nuts and
bolts.
Remove plate and bushing.
2.
Remove trailing arm pivot bolt and nut.
Position trailing arm out of the way to
gain
access to bushing retaining plate.
4.
Fit new bushing. Reverse removal procedures
and torque fasteners.
Note:
Quantity of removed shim washers should be
noted and replaced upon installation.
5. Check rear suspension for specified tow-in
alignment and adjust if
necessary.
.
•$
To Next Page
Loading...
