Delorean DMC - Page 427

9. Move the interior locking control rocker to the
lock position and then back to the unlock
position. Check both the mechanical and
electrical operation of the locking system.
10. With the system in the unlock position and
door open, return the latches to the release
position.
DOOR STRIKER MOUNTING
BRACKET, REAR
Removal
1. Make an alignment mark and remove rear
striker pin.
2. Raise vehicle on hoist.
3. Remove screws securing rear of rocker panel
to vehicle.
4. Pull rocker panel away from vehicle to allow
access to screws securing rear quarter panel to
body. Remove screws.
5. Lower vehicle on hoist.
6. Peel off outer door seal from rear quarter
panel.
7. Remove screws securing rear quarter panel to
body at rear of door opening.
8. Carefully pull quarter panel away from body
enough to remove two striker mounting
bracket retaining screws.
9. Partially remove door filler panel and remove
two remaining screws securing striker
mounting bracket.
10. Remove striker mounting bracket.
Installation
1. Position and secure striker mounting bracket.
2. Position and secure interior rear trim panel.
3. Position and secure rear quarter panel to filler
panel.
4. Raise vehicle on hoist.
5. Install screws securing rear quarter panel ro
underbody.
6. Position and secure rocker panel.
7. Lower vehicle on hoist.
8. Position and secure outer door weather strip
with specified adhesive.
9. Position and secure striker pin to alignment
mark.
10. Close door and check striker pin alignment.
Adjust as necessary.
DOOR, STRIKER MOUNTING
BRACKET, FRONT
Removal
1. Make an alignment mark and remove front
striker pin.
2. Raise vehicle on hoist.
3. Remove screws securing front of rocker panel
to vehicle.
4. Pull rocker panel away from vehicle to allow
access to screws securing front fender to
underbody. Remove screws.
5. Lower vehicle on hoist.
6. Peel off outer door seal from front fender.
7. Remove screws securing front fender to filler
panel.
8. Carefully pull fender away from vehicle enough
to remove two screws securing striker
mounting bracket to front pontoon.
9. Pull carpeting away from inner shroud and
remove two remaining screws securing striker
mounting bracket.
10. Remove striker mounting bracket.
Installation
1. Position and secure striker mounting bracket to
body.
I
J
"3.
f^i
f'
1
'i