English-3
Installation Method:
Step 1: Ensure to put waterproof gasket into HMI
and then insert the HMI into the panel cutout.
Step 2: Ensure to insert fasteners into the HMI’s
insertion slots and turn the screw till screws touch panel
cutout.
Step 3: Turn the screw with less than torque 0.7N.M to avoid damage to plastic box.
Torque: 6.17lb-inch(0.7N-M)
Power Line Installation
Recommended wiring is in the table below:
Type Wire Gauge (AWG) Stripped length Torque
Solid 28~12 7~8 mm 4.5 lb-in
Stranded 28~12 7~8 mm 4.5 lb-in
Be sure to plug power line into HMI according to following arrow direction.
DOP-AS38BSTD(-W) DOP-A(E)57G(B)(C)STD(-W)
To Next Page
Loading...