Delta-q IC650 - Page 5

6
1. Disconnect AC input from the charger, or from the
wall outlet. Wait 30 seconds for the input relay to
open.
2. While reconnecting AC input, press and hold the
Select Charge Prole Button. Hold the button
(approximately 10 seconds) through the light
check function until Error Indicator is on (in
amber) and Battery Charging Indicator (in green)
starts ashing.
3. Press and release the Select Charge Prole Button
to advance through charging proles loaded on
the charger. The selected charging prole will
be displayed up to three times (e.g. “P-0-1-1” for
Prole 11).*
*Process will time out and prole will remain
unchanged if there is 15 seconds of inactivity, a
prole number is allowed to display three times, or if
AC power is cycled.
4. Once the desired charging prole is displayed,
press and hold the Select Charge Prole button
for 10 seconds to conrm selection and exit
Prole Selection Mode. When the charge prole
is conrmed, the Error Indicator and Battery
Charging INdicator lights will turn o, while the
blue AC Power Indicator remains lit. At this point,
the button can be released.
5. Press the Select Charge Prole Button to check
that the desired prole is selected.
2.0 IC650 Conguration
There are two ways to alter the conguration on the IC650 Charger:
1. Use the Select Charge Prole Button.
2. Use a pre-programmed USB ash drive.
Figure 1.Disconnect AC input from the charger.
2.1 Selecting A Charge Prole Using the ‘Select Charge Prole Button’
Figure 2. Reconnect AC input while holding the
Select Charge Prole Button.
Figure 3. Press the Select Charge Prole Button
to advance through the charge proles. When the
desired charge prole appears, hold the button for 10
seconds to conrm your selection.