Delta-q IC650 - Getting Started

7
2.2 Conguring the IC650 Charger Using a USB Flash Drive
Using the Delta-Q software, USB storage drives can be pre-programmed to certain charger congurations.
To use the USB port, follow these steps:
1. Insert the USB ash drive at any time, but preferably not during a charge cycle. Stop the charge cycle by
removing AC power or the DC connection to the batteries. The charger can power the USB port from the
AC connection (DC disconnected) or from the DC connection (AC disconnected).
2. If there is enough disk space (about 2 mb), the charger will write charge tracking data to the drive. The
Fault / Error / USB Indicator will ash green during reading and writing.
3. If the drive contains compatible conguration les, the charger will load them.
4. The IC650 Charger will briey reset.
5. Remove the drive when the Fault / Error / USB indicator is solid green.
Figure 4.Insert the USB ash drive to begin the reprogramming process.
When complete, the Fault / Error / USB indicator will be solid green as shown.