Delta-q Milk QOOL - Using Your Coffee Machine; First-Time Setup Guide

EN INSTRUCTIONS AND MODE OF USE
70
USING YOUR COFFEE MACHINE
Using your coee machine for the first time
Confirm whether any accessories are missing and that the equipment is
not damaged.
Then clean the inner parts following the steps below:
• Remove all the protective materials and storage adhesives from the
machine components.
• Remove it and open the cover and fill with 1 L of water (see Fig. 3).
Once the water tank has been filled, replace it in the initial position and
confirm that it has been correctly fitted (see Fig. 4).
• Connect the electrical plug to the respective earthed socket.
• Switch the On/O general button which is located at the back of the
equipment (see Fig. 5).
The buttons on the control panel will blink in sequence (green colour)
when the equipment starts to pre-heat (approximately 1 minute)
(see Fig. 6).
• As soon as the buttons on the control panel stop blinking in sequence
(green colour), the pre-heating is over (see Fig. 7).
• Put a cup (with capacity exceeding 180cc) on the cup tray under
the extraction nozzle.
Press the tea extraction button/water button/purge to rinse the
machine, repeat three times.
Note: For cleaning the milk system see page 84.
Fig. 3: Remove the water tank and fill
with water.
Fig. 4: Install the water tank in the
machine.
Fig. 5: On/O general button.
Fig. 6: Pre-heating of equipment.
Fig. 7: Ready for use.
A.
B.
C.
D.
A.
B.
C.
D.