EN INSTRUCTIONS AND MODE OF USE
16
Extracting a beverage in a tall glass
• If you wish to extract a beverage (espresso coee, coee or
tea) into a receptacle whose height is greater than the distance
between the cup tray and the extraction nozzle in its initial
position, please follow these instructions:
• Lower the cup tray (see Fig. 13).
• Place a tall glass on the cup tray and below the extraction
nozzle (see Fig. 15).
• Press the control panel button corresponding to the drink desired.
• Follow the steps relating to extracting the selected drink in
accordance with the paragraphs above.
Warning: If, during the beverage preparation, there is
any alert because of a lack of water, blockage or fault
in the used capsule tank, the equipment will/must be
stopped immediately.
(For further information about the meaning and definition of the
alerts and the luminous alarms, consult the “Alerts and Alarms”
chapter (see Page 22).
• The equipment returns to the “Ready to use” mode and all the
luminous indicators of the control panel buttons are illuminated
green (see Fig. 7).
• Empty the used capsule tank and the drip basin frequently.
• Always turn o the coee machine by pressing/switching the
On/O general button.
Fig. 15: Extracting a beverage in a tall
glass
To Next Page
Loading...
