Chapter 11 Convenient Functions
11-13
The present network created in NWCONFIG is shown below. The slave station to which the station
address 1 is assigned is a DVP-SV2 series PLC. After the data exchange table in the DVP-SV series PLC
is uploaded, the device types shown in the data exchange table in the PLC Link Table Editor window will
be consistent with the device names shown in the working area in NWCONFIG. The device ranges set for
the DVP-SV2 series PLC is not within the device range for DVP-SV2 series PLC, and therefore “Disabled”
appears in the Status cell for the DVP-SV2 series PLC.
D. Managing a Data Exchange Table
There are buttons under the data exchange table in the PLC Link Table Editor window. Please refer to the
table below for more information about the buttons. If users click
, the system will lead the users
to the previous step.
Export
The data in the data exchange table can be exported as a CSV file. The users can
edit the CSV file through Microsoft Excel. The CSV file can also be used as
reference material for another development work.
Reset
After the users click the button, the setting in the data exchange table will be
restored to the initial setting.
After the users click the button, the data exchange table will be checked.
Upload
After the users click the button, the parameters related to a PLC Link in the master
station will be uploaded.
Download
After the users make sure that the setting of a PLC Link is correct, they can
download the setting to the master station by clicking the button.
After the users make sure that the setting of a PLC Link is correct, they can
To Next Page
Loading...
