(6) Hardware specifications
Model DOP-103BQ
Display
Panel type 4.3" TFT LCD (65535 colors)
Resolution 480 x 272 pixels
Backlight
LED backlight (half-life under room temperature 25
o
C > 20,000 hours)
*1
Display range 95.04 x 53.856 mm
Brightness 400 cd/m² (Typ.)
CPU
ARM Cortex-A8 (800 MHz)
Flash ROM
256 Mbytes
RAM
256 Mbytes
Touchscreen
4-wire resistive touchscreen > 1,000,000 operated
Buzzer Multi-tone frequency (2 K – 4 KHz) / 80 dB
Network interface N/A
USB 1 USB slave Ver 2.0; 1 USB host Ver 2.0
SD N/A
Serial
communication
port
COM1 RS-232 (supporting flow control) / RS-485
*2
COM2
RS-422 / RS-485
*2
COM3 N/A
Auxiliary function key N/A
Calendar Built-in
Cooling method Natural cooling
Approvals
CE / UL (please use shielding network cable and magnetic ring with the filter of
300 ohm / 100 MHz)
Panel waterproof level IP65 / NEMA 4
Operation voltage
*2
DC +24V (-15% to +15%) (please use an isolated power supply)
Supplied by Class 2 or SELV circuit (isolated from MAINS by double insulation)
Leakage current 500 V
AC
for 1 minute (between DC24V terminal and FG terminal)
Power consumption
*2
5.67W (Max)
*3
Backup battery
3V lithium battery CR2032 × 1
Backup battery life
About 3 years or more at 25
o
C
(subject to operation temperature and condition)
Operation temperature 0
o
C to 50
o
C (32
o
F to 122
o
F)
Storage temperature -20
o
C to +60
o
C (-4
o
F to 140
o
F)
Operating environment
10% to 90% RH [0
o
C - 40
o
C], 10% to 55% RH [41
o
C - 50
o
C];
pollution degree: 2
Vibration resistance
Conforms to IEC61131-2: continuous vibration 5 Hz - 8.3 Hz with amplitude
3.5 mm; 8.3 Hz - 150 Hz with amplitude 1G
Shock resistance
Conforms to IEC60068-2-27:
11 ms, 15 G Peak, in X, Y, Z directions each for 6 times
Dimension
(W) x (H) x (D) mm
137 x 103 x 37.1
Mounting dimension
(W) x (H) mm
118.8 x 92.8
Weight
Approx. 280g
Note:
1. The half-life of the backlight is defined as the maximum luminance being reduced by 50% when the
maximum drive current is supplied to the HMI. The life of LED backlight shown here is estimated at the
room temperature of 25
o
C with ambient humidity.
2. The withstand voltage of the isolated power circuit is 1500V peak for 1 minute.
3. The HMI power consumption is the power consumed when the HMI is not connecting with other
peripheral devices. To ensure normal operation of the HMI, the recommended capacity of the power
supply is 1.5 to 2 times of the specified power consumption.
4. Isolated power supply is recommended.
5.
6. DOP-100 series can be used with other industrial automation equip
m
ent. Please read through this
sheet carefully and install the product according to the instructions to avoid danger.
To Previous Page
Loading...
