Delta DOP-B07 Series User Manual

DOP- B07S(E)515 DOP- B07PS515 (Front View)
A Power LED Indicator (Lights in green when HMI works normally.)
B Touch Screen / Display
DOP- B07S(E)515 DOP- B07PS515 (Rear View)
A Power Input Terminal F USB Slave
B COM2 (can be extended to COM3
(Note1)
) G System Key
C COM1 H Ethernet Interface (LAN)
D Memory Card Slot / Battery Cover I Audio Output Interface
E USB Host - -
NOTE
1. For the setting method, please refer to the pin definition of serial communication.
(5) Dimensions
DOP- B07S(E)415 DOP- B07PS415
DOP- B07S(E)515 DOP- B07PS515
184(7.24")
144 (5.67")
+1.0
172.4
0
T
+1.0
132.4
0
(5.21" )
Note:
T=1.6mm(0.063")~
6mm(0.24")
+0.04"
(6.79" )
0
+0.004"
0
43(1.69")
131(5.16")
(6) Specifications
MODEL
DOP-B07
S415
DOP-B07
E415
DOP-B07
PS415
DOP-B07
S515
DOP-B07
E515
DOP-B07
PS515
LCD MODULE
Display Type
7” Widescreen TFT LCD
(65536 colors)
7” TFT LCD
(65536 colors)
Resolution 800 x 480 pixels 800 x 600 pixels
Backlight
LED Back Light (less than 20,000 hours
hal
f
-life at 25
o
C)
(Note 1)
LED Back Light (less than 10,000 hours
hal
f
-life at 25
o
C)
(Note 1)
Display Size 152.4 x 91.44mm 141 x 105.75mm
Operation System
Delta Real Time OS
MCU 32-bit RISC Micro-controller
NOR Flash ROM
Flash ROM 128 MB
(OS System: 30MB / Backup: 16MB / User Application: 82MB)
SDRAM 64Mbytes
Backup Memory 16Mbytes
Sound
Effect
Output
Buzzer
Multi-Tone Frequency 2K ~ 4K Hz 85dB
AUX
N/A Stereo output N/A N/A Stereo output N/A
Ethernet Interface N/A
IEEE 802.3,
IEEE 802.3u
N/A N/A
IEEE 802.3,
IEEE 802.3u
N/A
10/100
Mbps
auto- sensin
g (has
built- in
isolated
power
circuit
(Note
3)
10/100 Mbps
auto- sensing
(has built- in
isolated
power circuit
(Note 3)
USB
1 USB Host
(Note 2)
Ver 1.1 /
1 USB Slave Ver 2.0
Memory Card SD Card (supports SDHC)
Serial
COM
Port
COM1 RS- 232 (supports hardware flow control)
COM2
RS-232
RS-422
RS-485
RS-232
RS-422
RS-485
(has built- in
isolated
power circuit
(Note 3)
RS-232
RS-422
RS-485
RS-232
RS-485
RS- 232 /
RS- 485
(has built- in
isolated
power circuit
(Note 3)
)
RS-232
RS-485
COM3
RS-232
RS-422
RS-485
RS-232
RS-422
RS-485
(has built- in
isolated
power circuit
(Note 3)
RS-232
RS-422
RS-485
RS-422
RS-485
RS- 422 /
RS- 485
(has built- in
isolated
power circuit
(Note 3)
)
RS-422
RS-485
Function Key N/A
Perpetual Calendar
(RTC)
Built- in
Cooling Method Natural air circulation
Safety Approval
CE UL
(Note 4)
KCC
(Note 4)
Waterproof Degree
IP65 NEMA4
Operation Voltage
(Note 5)
DC +24V
-10% ~
+15%
(please use
isolated
power
supply)
DC +24V
-10% ~
+15%
has
built- in
isolated
power circuit
(Note 3)
DC +24V
-10% ~
+15%
(please use
isolated
power
supply)
DC + 24V
(- 10% ~
+ 15%)
(please use
isolated
power
supply)
DC + 24V
(- 10% ~
+ 15%)
(has built- in
isolated
power circuit
(Note 3)
)
DC + 24V
(- 10% ~
+ 15%)
(please use
isolated
power
supply)
Voltage Endurance
AC500V for 1 minute (between charging (DC24V terminal) and FG terminals)
Power Consumption
(Note 5)
5W 7.5W 5W 7.68W
Backup Battery 3V lithium battery CR2032 x 1
Backup Battery Life
It depends on the temperature used and the conditions of usage,
about 3 years or more at 25
o
C.
Operation Temp.
0
o
C ~ 50
o
C
Storage Temp.
-20
o
C ~ +60
o
C
Ambient Humidity
10% ~ 90% RH [0 ~ 40
o
C], 10% ~ 55% RH [41 ~ 50
o
C]
Pollution Degree 2
Vibration
IEC 61131- 2 compliant 5Hz f 8.3Hz = Continuous: 3.5mm, 8.3Hz f 150Hz =
Continuous: 1.0g
Shock IEC 60068- 2- 27 compliant 15g peak for 11 ms duration, X, Y, Z directions for 6 times
Dimensions
(W) x (H) x (D) mm
215 x 161 x 50 184 x 144 x 50
Panel Cutout
(W) x (H) mm
196.9 x 142.9 172.4 x 132.4
Weight Approx.970g Approx.800g
NOTE
1) The half- life of backlight is defined as original luminance being reduced by 50% when the maximum driving current is
supplied to HMI. The life of LED backlight shown here is an estimated value under 25
o
C normal temperature and humidity
conditions.
2) USB Host port can provide up to 5V/ 500mA of power.
3) The withstand voltage of the isolated power circuit is 1500V peak for 1 minute.
4) Some models are in the process of application to UL and KCC certification. For more information, please consult our
distributors.
5) The value of the power consumption indicates the electrical power consumed by HMI only without connecting to any
peripheral devices. In order to ensure the normal operation, it is recommended to use a power supply which the capacity is
1.5 ~2 times the value of the power consumption.
6) The content of this quick start may be revised without prior notice. Please consult our distributors or download the most
updated version at
http://www.delta.com.tw/ia/ .
A
B
C
B
A
F
G
E
H
I
D
Units mm (inches)
Units
mm (inches)

Delta DOP-B07 Series Specifications

General

Brand	Delta
Model	DOP-B07 Series
Category	Touch terminals
Language	English