Delta M30A 230 - Auto ID Commission Tool Usage; Auto ID Setting Process

YES
4.2 Auto ID Commission Tool
ATTENTION
Figure 4-2: Steps of auto ID setting by tool
1
Open the software
1. Select COM Port and click
2. Enter the number of Inverters and press
3. Show the inverter serial number and ID,
and the status display OK is completed.
The Auto ID function could set all inverter IDs at monitoring center after wiring RS-485.
4.2.1 Auto ID Setting
2
Please download the software from the following website:
https://mydeltasolar.deltaww.com/dl_installer_guide.php?f=autoid
42
Commissioning