Delta M30A 230 - AC SPD Replacement Steps

5.2.1 Replace AC SPD
* Screw torque: 0.8 N•m
* Screw torque: 0.8 N•m
Figure 5-5: Steps of changing AC SPD
1. Turn off the AC and DC power, and wait until the LED indicators turns off.
2. Follow Section 5.1.1 to open the door.
3. Loosen the screw and remove protective cover.
4. Loosen 3 screws, remove wires and disconnect signal cable to take off AC SPD.
5. Install the new AC SPD unit with procedures above in reverse order and
tighten the screw with 0.8 N∙m torque.
6. Install the protective cover and tighten the screw with 0.8 N∙m torque.
7. Follow Section 5.1.2 to close the door.
51
Maintenance