Foundation
The PCS cabinet is recommended to be mounted on a concrete floor. Follow the illustration below
to prepare the groundwork.
Before installing a PCS cabinet, it is recommended to have a solid foundation established. The
following information is provided to serve as a guide for the setup of a recommended foundation.
The footprint boundary area of the PCS is 600 x 500 mm, and there are two ways for mounting:
1.
Mounting by the left and right sides of the unit base: Drill four holes for M12 expansion bolts
(not provided with PCS100HV) at the 4 corners of an area of 537 x 300 mm as marked in
number 1.
2.
Mounting by the front and rear sides of the unit base: Drill four holes for M12 expansion bolts
(not provided with PCS100HV) at the 4 corners of an area of 437 x 300mm as marked in
number 2.
Figure 4. Mounting Layout and Anchoring Holes Placement Variations (Top View)
Once the anchoring holes are completed, insert the expansion sleeves (not provided with PCS100HV)
into the anchoring holes:
Remove four M12 expansion bolts from the accessory kit.
Separate the nuts and washers from the bolts.
Once the expansion sleeves are individually separated, insert each one into the anchoring
holes.
To Next Page
Loading...
