Delta PCS100HV - Communication and I;O Wiring and Terminal Resistor Setting

Installation Manual
28
Wiring Instructions
Communication and I/O Wiring and terminal resistor setting
Get the wires with connectors or terminals prepared for communication and I/O connection through
the front square hole of the unit base
Plug these connectors into the relevant connector bases built-in at the inner left side wall of the
cabinet adjacent to the DC terminals as the following figure:
Figure 22. Communication and I/O Connection Location
Figure 23. Communication wiring through the front square hole
4
5
7
6
3
1
2
14
13
12
11
10
8
9