Delta ShopMaster MS350 - Fastening Machine to Supporting Surface

Fig. 5 Fig. 6
MOVING CUTTINGHEAD TO THE UP POSITION
1. Push down on switch handle (A) Fig. 5 and pull out cuttinghead lock knob (B).
2. Move the cuttinghead (C) to the up position (Fig. 6).
ATTACHING DUST BAG
1. Attach dust bag (A)Fig. 7 to the dust spout (B)
making sure the wire ring (C) is engaged between the
ridges in the spout.
C
B
FASTENING MACHINE TO
SUPPORTING SURFACE
Before operating your compound miter saw, make sure
it is firmly mounted to a sturdy workbench or other
supporting surface. Four holes are provided, two of which
are shown at (A) Fig. 8.
When frequently moving the saw from place to place, we
suggest that the saw be mounted to a 3/4" piece of
plywood. Use "C" clamps to secure the plywood to a
supporting surface.
Fig. 7
Fig. 8