20
Fig. 34
Fig. 35
CORRECT
INCORRECT
Fig. 36
C
B
A
C
For support when cutting long pieces, construct a work
support extension. Fig. 36 illustrates the miter saw mounted
on two standard 2 x 4’s (A). Fasten the four mounting legs (two
of which are shown at (B) Fig. 36 to the 2 x 4’s, using four
screws (not supplied) through the four holes in the mounting
legs. The length of the 2 x 4’s (A) can vary, depending on the
workpiece.
NOTE: Ensure that the top of the support 2 x 4’s (C) are
level with the miter saw table. This is critical because the
distance from the top of the 2 x 4’s (A) to the miter saw table
varies from saw to saw. In most cases, standard 2 x 4’s (C)
can used. If these are too high, cut them to fit. If the 2 x 4’s are
too low, use 2 x 6’s. If these are high, cut them to the correct
height.
WORK SUPPORT EXTENSIONS
To Next Page
Loading...
