8
UNPACKING
1. Carefully remove the machine from the carton.
Retain all packing materials until you have inspected
and satisfactorily operated the machine.
DO NOT OPERATE THIS MACHINE
UNTIL YOU READ AND UNDERSTAND THE
ENTIRE INSTRUCTION MANUAL.
2. Place the machine on a firm, level surface with extra
room for handling and proper support of the
workpiece.
3. Familiarize yourself with all features and controls
explained in this manual.
4. The machine is shipped with the cuttinghead locked
in the down position and the table rotated to 45° left,
Fig. 2. To release the head and move it to the
operating position, see “MOVING CUTTINGHEAD
TO THE UP POSITION” and “MOVING THE TABLE
TO THE 0° CUT-OFF POSITION” in this manual (Fig.
5 & 7).
5. Unassembled items are shown in Fig. 3 for
identification and use in assembling the saw.
Fig. 3
1
2
4
7
8
9
11
3
5
6
10
12
B
Fig. 4
A
13
Fig. 2
ASSEMBLY
CARTON CONTENTS
ASSEMBLY TOOLS REQUIRED
*
1
/2" arbor and fence wrench
(supplied)
* 1/4” hex wrench (supplied)
* Open end 7/16 wrench (supplied)
* 1/8” hex wrench (supplied)
* 5/16 socket wrench or adjustable wrench
*Phillips head screw driver
* Framing square
* C-clamps and plywood for support
ASSEMBLY TIME ESTIMATE
Assembly time for this product will be about 30 minutes to an hour.
1. Extension table
2. Fence slide
3. Fence slide support
4. Dust bag
5.
1
/2" arbor and fence wrench
6. ¼" hex wrench
7.
7
/16" open end wrench
8. Lock handle for slide fence
9.
5
/16" flat washer
10.
5
/16" lock washer
11.
5
/16"- 18 x 1
1
/4" long hex head screw (2)
12.
5
/16" - 18 x
3
/4" long hex head screws (2)
13.
1
/8" hex wrench
To Next Page
Loading...
