VIVOTEK
User's Manual - 13
4. Route an Ethernet cable through the hole, and ensure the cable joints are waterproof
using putties and tapes.
3. Drill holes for mounting screws and a cabling hole if applicable. Pull a CAT5e Ethernet
cable through the hole. Secure the camera to wall or ceiling using the included screws.
Ø ≥25mm
Cable molding
Layer - Self-fusing tape
or electric tape
2cm
2cm
1. Stretch the waterproof tape by twice its length and
wind around the cables.
2. The tape should overlap the cable joints by 20mm.
3. All connectors, whether they are used or not,
should be waterproof.
To Next Page
Loading...
Need help?
General
