Starting the skimmer
- position the skimmer in the sump
- feed water into the skimmer compartment (if applicable)
- open the water level adjuster fully by turning it clockwise
- start the skimmer pump
- turn the water level adjuster anti-clockwise until fine bubbles are visible between the
bayonet and the bottom of the skimmer cup (diagram c)
- initially keep the foam level in the skimmer cup low to avoid over skimming and
possible flooding of the cup
- wait a minimum of 24 hours before the final adjustment
- turn the water level adjuster in or out until the fine air bubbles start bursting
approximately half way up the cups riser tube
- for dry foam turn the water level adjuster clockwise
- for wet foam anti-clockwise
- Important: Never allow the pump to run dry.
-10-
To Next Page
Loading...
