EN
Operation with Ozone
The Skimmer can be operated with ozone up to max. 50 mg/h per pump. One air connection of the ozoniser should be connected via
a suitable silicon hose to the protein skimmer pump. The air is automatically sucked in the ozoniser by the skimmer pump. Should
the skimmer performance deteriorate please check the ozoniser for blockage.
Fresh salt water
If the skimmer is used with new water on an aquarium it is common for you to find an excessive quantity of small bubbles produced
and often the skimmer cup fills with a clear liquid. This is due to the high surface tension of the new water which prevents the
bubbles from bursting. Once the water matures this effect will do away but can take up to 2-3 weeks. The effect is different on
different salt brands and is often dependant on levels of conditioning agents added to the salt. Once these are skimmed out then the
skimmer will act normally.
Heavier feeding in the initial stages will give the chemically pure water something to react with and allow it to mature into proper
aquarium salt water rather than the initial chemical soup which is new salt water.
Technical Data
mm
litre
litre/h
technical
Footprint
Footprint
with Pipe
work
height
Height
under
outlet pipe
high
stocking
normal
stocking
min. max.
TC 1655 290x190 372x192 570 253 1200 1000 1500
Watt
litre/h
mm
technical
min. max. min. max. Feed line
Outlet
TC 1655 12 800 25 40
-14-
To Next Page
