1. HANDLEBAR
HANDLEBAR COMPONENTS HAS BEEN PREASSEMBLED
Please tighten and secure all bolts
1.
Unscrew the bolts and remove the
covers, bolts and sleeves, leaving all
washers in place.
2. Place the handlebar riser on the
front fork, tighten the bolts on the top
of the stem, and fix the stem on the
front of the bicycle.
3. Loosen the fixing screws between
the stem and the handlebar,
and adjust the handlebar to an angle
which is comfortable for riding.
4. Align the handlebar with the center
position, tighten and fix the bolts on
both sides of the handlebar.
5. Add Top Cap to Stem Bolt. 6. Upon final assembly, revisit this
step to confirm alignment with stem
and front wheel.
You will use the 5mm allen key on the multi tool for these steps.
To Next Page
Loading...